Поиск

Товары для мебели

Topcoat Paints

Код товара:632-Seri

It is an air drying, NC based primer.

Place of use

ÜNPA FLASH NC PRIMER (632 SERIES) has very fast drying and easy sandability property. It has a fuller appearence in the surface.

Technical Information

Density (20°C , gr/cm³ ) : 1,42 - 1,46
Soldi Matter : 63,0 - 67,0
Thinner : NC Thinner (961-0621)
Dilution Ratio : 100/90-100
Sanding Time(20°C ,300 gr/m²) : 2-3 hours
Coverage : An area of 10-12 m² is coated by using 1 lt of this product remains a dry film of 35-40 µ (excluding application loss)

Instructions

Wooden surface is sanded properly and cleaned from dust before the application. Depending on the application method, it should be brought to proper viscosity. Acccording to the required film thickness, it should be applied as three/five coats with 10-15 min. intervals between each layer. It has to be  sanded after min.two hours and then clear topcoat must be applied. For the applications excluding spray; it should be consulted to our technical service department.

Topcoat Paints / Товары на целлюлозной основе / Товары для мебели / Продукты - Katsan Group

Поиск

Товары для мебели

Topcoat Paints

Код товара:632-Seri

It is an air drying, NC based primer.

Place of use

ÜNPA FLASH NC PRIMER (632 SERIES) has very fast drying and easy sandability property. It has a fuller appearence in the surface.

Technical Information

Density (20°C , gr/cm³ ) : 1,42 - 1,46
Soldi Matter : 63,0 - 67,0
Thinner : NC Thinner (961-0621)
Dilution Ratio : 100/90-100
Sanding Time(20°C ,300 gr/m²) : 2-3 hours
Coverage : An area of 10-12 m² is coated by using 1 lt of this product remains a dry film of 35-40 µ (excluding application loss)

Instructions

Wooden surface is sanded properly and cleaned from dust before the application. Depending on the application method, it should be brought to proper viscosity. Acccording to the required film thickness, it should be applied as three/five coats with 10-15 min. intervals between each layer. It has to be  sanded after min.two hours and then clear topcoat must be applied. For the applications excluding spray; it should be consulted to our technical service department.